Quote Originally Posted by cffisher View Post
Not sure how the trans mount would effect the engine mounts in the way he explains the problem..........If you have access to another truck I'd sure measure it and compare...ONE request when you figure this out post the answer cause there are a lot of us stumped..
I agree, Charlie. The tranny mount could affect the front to back MM position, but I cannot see how it could affect the spread of the mounts which is what's placing them a hair too high relative to the frame. How about if you slot your MM holes where they bolt to the block toward the top about 1/8" to 1/4", shifting your MM's down on the block a smidgen, which will put them just a bit closer together, dropping them down deeper between the frame rails. I cannot see that a minor slotting will affect your mount in any way as long as it's equal on both sides.