Thread: machine shop estimate?
Threaded View
-
12-20-2010 12:22 PM #12
yep i get 10.00 a rod for the big end . wash then blast then cut caps and rods .press bolts in hone to size .add for bolts i only use SPS or ARP s . small ends on stock rods are touch up there never off that bad like Jerry said the after market have about a 001.3 to much on the pin end.to re hang pistons with oven and check for twist 40.00 so about the sameIrish Diplomacy ..the ability to tell someone to go to Hell ,,So that they will look forward to to the trip
John's ride to the cemetery, his beloved Billings OK bus, The Baby Elephant!! Traveling in style!! As his service was starting I couldn't figure out what the music was, heavy on a flute in a jaunty...
John Norton aka johnboy