Thread: 383 build

Tweet

There are a few downloads on the net
1) camquest 6; is free from competition cams. Pretty close the times that I used it. http://www.compcams.com/Pages/409/camquest-6.aspx
2) desktop dyno; I have used this one a few times but it always show higher torque numbers than actual.
3) Dynosim 5 ; I have never used this one but know some guys that have & they swear it is dead on
I'm sure there are alot more out there. Just remember enter as much info as you can Garbage in garbage out.

Originally Posted by fun4me

There are a few downloads on the net
1) camquest 6; is free from competition cams. Pretty close the times that I used it. http://www.compcams.com/Pages/409/camquest-6.aspx
2) desktop dyno; I have used this one a few times but it always show higher torque numbers than actual.
3) Dynosim 5 ; I have never used this one but know some guys that have & they swear it is dead on
I'm sure there are alot more out there. Just remember enter as much info as you can Garbage in garbage out.

Thanks! I'll grab one or two of those and see what I get. Appreciate the info!

Originally Posted by fun4me

There are a few downloads on the net
1) camquest 6; is free from competition cams. Pretty close the times that I used it. http://www.compcams.com/Pages/409/camquest-6.aspx
2) desktop dyno; I have used this one a few times but it always show higher torque numbers than actual.
3) Dynosim 5 ; I have never used this one but know some guys that have & they swear it is dead on
I'm sure there are alot more out there. Just remember enter as much info as you can Garbage in garbage out.

Wow, I downloaded Engine Analyzer Pro... I thought using the cam spec sheet and basic head info I could get results... I think I need to go to school to use it. haha

Went to the camquest... I'll see how that works. =)

Thanks again!