Thread: 350 roller

Tweet

Originally Posted by bones113

lookin for some advice help suggestions..on a cam.....i have a 5.7 out of a 91 police car has factory flat tops gonna put a set of world product 17cc 2.02/1.06 heads carbed going to run a 400th..factory stall....not gonna be street driven..not sure compression ratio.... been looking at zz4 and lt4 hot cams...so got any advice....

Not gonna be street driven. OK, where will it be driven?
Can't intelligently choose a cam without knowing the static compression ratio.
Factory stall won't take much cam and "not much cam" won't take much static compression ratio.
Stop looking at cams until you know how to figure SCR.
You'll need:
1. cylinder volume in cc's
2. chamber volume in cc's
3. piston crown volume in cc's
4. piston deck height volume in cc's
5. head gasket volume in cc's
Is this a roller cam block?