Thread: 283 balancer bolt
-
09-26-2009 07:30 PM #1
283 balancer bolt
hi ya'll ; Does a 283 sbc have the typical 7/16 20 tpi balancer bolt ? The crank I have had a bolt broke off in the snout , so I drilled it out 25/64 and tapped it 7/16 just wandering if thats the right size ? not that it really makes any difference now.Last edited by suprstock; 09-26-2009 at 07:38 PM. Reason: retard
-
Advertising
- Google Adsense
- REGISTERED USERS DO NOT SEE THIS AD
-
09-26-2009 08:23 PM #2
i never seen a 283 with a damper bolt ? guys drill and tap them so you do not beat the hell out of the damper to get it on. when tap out you can used the tool to put the damper on yes sbc is 7/16 fine and bbc is 1/2 fineIrish Diplomacy ..the ability to tell someone to go to Hell ,,So that they will look forward to to the trip
-
09-26-2009 08:51 PM #3
SBC 7/16-20 x 2 1/4PLANET EARTH, INSANE ASYLUM FOR THE UNIVERSE.
-
09-26-2009 08:57 PM #4
yes 7/16 -20Last edited by pat mccarthy; 09-26-2009 at 09:16 PM.
Irish Diplomacy ..the ability to tell someone to go to Hell ,,So that they will look forward to to the trip
-
09-28-2009 04:41 AM #5
thanks buds, so they did'nt have a bolt from the factory , how then ? pressed or hammered on?302 c.i. of knowledge power
Well I've sure gotten old too so don't worry about it! I've had two bypass surgeries, new knees, fought prostate, cancer and diabetes. I'm half blind, can't hear anything quieter than a jet engine,...
the Official CHR joke page duel