Welcome to Club Hot Rod!  The premier site for everything to do with Hot Rod, Customs, Low Riders, Rat Rods, and more. 

  •  » Members from all over the US and the world!
  •  » Help from all over the world for your questions
  •  » Build logs for you and all members
  •  » Blogs
  •  » Image Gallery
  •  » Many thousands of members and hundreds of thousands of posts! 

YES! I want to register an account for free right now!  p.s.: For registered members this ad will NOT show

 

Thread: Tightening valves after break-in
          
   
   

Reply To Thread
Results 1 to 2 of 2

Hybrid View

  1. 04-13-2009 03:05 PM #1
    sgo70's Avatar
    sgo70
    sgo70 is offline CHR Member/Contributor
    Visit my Photo Gallery
    Join Date
    Nov 2007
    Location
    Calgary
    Posts
    496

    Tightening valves after break-in

     



    Okay as some of you know I just built a 383 with AFR heads. So now that I have done the break-in procedure I went back and replaced all my inner valve springs. Now I'm not sure if the procedure for tightening the rockers down is any different than before. Could anyone offer some input here??? Oh yea, I have hyd flat tappet valves.

    And thanks to you guys I was looking at my valves and the wear pattern from the rollers is dead center of the valves. Looks like you can beat some things into a dummy.

    Sean
    Reply With Quote Reply With Quote
  2. 04-13-2009 03:33 PM #2
    sgo70's Avatar
    sgo70
    sgo70 is offline CHR Member/Contributor
    Visit my Photo Gallery
    Join Date
    Nov 2007
    Location
    Calgary
    Posts
    496

    Also, should I re-torque my heads while the covers are off.

    Sean
    Reply With Quote Reply With Quote
Reply To Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Forum Rules

Links monetized by VigLink