Thread: sbc lifter question
Threaded View
-
03-09-2008 11:31 AM #1
sbc lifter question
Hello out there to everyone!
Got a question need some advice. Pulled my engine out of my boat to replace freeze plugs that leaked. Compression was low on 2 cylinders so pulled heads to get them checked out. While cleaning the head gaskit material off block using air compressor to blow off. one of the keepers on one of the lifter blew out. I'm not sure how the lifter works but I assume it is compressed and this keeper keeps it compressed. Is this correct? My question is if this lifter is not compressed would this cause engine to miss or what effect would it cause?
Thanks all.
Leonard.
Awesome, I will put 5 quarts in when the time comes. I've always used Valvoline, what viscosity would be recommended for So.Cal.?, and thanks again
SB distributor won't fit