Welcome to Club Hot Rod!  The premier site for everything to do with Hot Rod, Customs, Low Riders, Rat Rods, and more. 

  •  » Members from all over the US and the world!
  •  » Help from all over the world for your questions
  •  » Build logs for you and all members
  •  » Blogs
  •  » Image Gallery
  •  » Many thousands of members and hundreds of thousands of posts! 

YES! I want to register an account for free right now!  p.s.: For registered members this ad will NOT show

 

Thread: Sbc 327 - Need Help Big Time!!!
          
   
   

Results 1 to 15 of 15

Threaded View

  1. 01-17-2007 10:30 PM #6
    66AztecMalibu
    66AztecMalibu is offline CHR Member
    Visit my Photo Gallery
    Join Date
    Jan 2007
    Location
    Baton Rouge
    Posts
    6

    I'm almost certain the valves were adjusted correctly. Followed instruction to the letter... tightened until pushrod barely moved by hand (at right time and stroke) - then tightened 1/4 turn. Not sure if anything bent/broke yet - too depressed to open the motor again right away. Installed all new parts. My "advisors" all run super high end 1/4 mile race motors - all solid lift not hydraulic so not sure if that played into it. Three intake valves (judging by rockers) not moving so assuming wiped lobes off of cam...
    Cam timing was set "dot to dot" and then at 30 degree mark on balancer pulley.
    Last edited by 66AztecMalibu; 01-17-2007 at 10:33 PM.
    Reply With Quote Reply With Quote

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Forum Rules

Links monetized by VigLink