Thread: converting to high compression
-
11-12-2003 08:25 AM #1
converting to high compression
I'm gonna be putting a hypereutectic piston kit on my 350 that will give it 11.93 : 1 compression and I was wondering if there is anything special I should do.?
-
Advertising
- Google Adsense
- REGISTERED USERS DO NOT SEE THIS AD
-
11-12-2003 09:30 AM #2
Also listen to see if your valves smack your pistons or if it runs crappy see if your smashing plugs, thats a lot of compression, is this a street car?? If it is i would think that over again before you go putting those in, Theres a huge misconception that huge compression gives you huge horse, maybe if your making 1500 horse then that one compression point will cost you 100 horse, til then, its a waste of money.
In my experience you need only two tools in the workshop: WD40 if it doesn't move and it should, and duct tape if it does move and it shouldn't. .
the Official CHR joke page duel