Thread: main cap mixed up
Threaded View
-
11-01-2006 02:25 PM #1
main cap mixed up
Called the machine shop today to check on my block. I did not mark my mains but they were in there correct positions when I took the block to be bored. He did not mark them, now he is going to have to torque and gauge them to try and match the caps where they go. So should he charge me for that? or should we split the cost since we both failed to mark them?
I had to go to the doctor's this morning. He told me that my sugar was too high so I came home and put it on a lower shelf. I feel better already.
the Official CHR joke page duel