Thread: Stock Rocker/ Easy Question
Hybrid View
-
09-30-2006 11:19 AM #1
Stock Rocker/ Easy Question
can i use the same method to adjust roller rockers (zero lash method. car non started) for a chevy 350's stock rockers? thank you guys
-
09-30-2006 11:26 AM #2
Well, from what I have learned from the people on this site you can provided you are talking about hydrualic lifters. Tighten down till there is no slop in the pushrod and then a 1/4 - 1/2 turn, if I remember correctly. Welcome to the forum and I'm sure you will find a lot of helpful info here as these people know what they are talking about.
-
09-30-2006 11:35 AM #3
i would think you could
-
09-30-2006 02:46 PM #4
Yep, just make sure the lifter is on the heel of the cam lobe. Turn the bolt in the center of the harmonic damper with a bar and socket until the valve is at full lift, then turn the damper one full turn (360 degrees). That will put the lifter on the heel of the lobe. Start at #1 cylinder (closest to radiator, driver's side). After you have done #1 intake, turn the damper 1/4 turn (90 degrees) (clockwise looking at the motor from the front of the car) and adjust #8 (passenger side next to firewall) intake, then another 1/4 turn and adjust #4 (passenger side, second from front) intake, then another 1/4 turn and adjust #3 (driver's side, second from front) intake and so on through the firing order 1-8-4-3-6-5-7-8. Then go back and find full lift on #1 exhaust, one full turn, adjust it, then 1/4 turn and adjust #8, and so on and so on.Last edited by techinspector1; 09-30-2006 at 02:48 PM.
PLANET EARTH, INSANE ASYLUM FOR THE UNIVERSE.
On a bitterly cold winter morning a husband and wife were listening to the radio during breakfast. They heard the announcer say, "We are going to have 8 to 10 inches of snow today. You must park...
the Official CHR joke page duel