opinions on performance specs
Your engine summary is as follows:
Bore - 3.770 inches
Stroke - 3.48 inches
Rod c-c length - 5.7 inches
With a static compression ratio of 9.83:1.
Your camshaft specifications call for an inlet valve closing of 57 degrees ABDC (after bottom dead center).
Your chamber volume is 72.09 cc's. With this camshaft your dynamic, or effective stroke is 2.88 inches.
Your dynamic compression ratio is 8.31 :1 corrected for cam timing, altitude, and rod length.
Your dynamic cranking pressure, corrected for cam timing, rod length and altitude is 167.00 PSI.
Your dynamic boost compression ratio, reflecting static c.r., cam timing, altitude, and boost of 0 PSI is 8.31 :1.
From these specs ,What would be your thoughts on how this will perform in a weekend cruzer ,at 3500 lbs with a 4.11 rear end and stickshift.This is my engine specs for the truck I am rebuilding.:) thnx for any feedback.The only info left out that I saw,58 cc heads and 8cc dish piston..010 under mains and milled heads,so the chamber may be 1-2 cc smaller and decked block.Plus I have installed rhodes lifter,which claim to knock off about 10 deg. under 3000 rpm of cam duration,the actual cam is xe262 flat tappet hydralic.
