350 motor

ok im going to build a small street motor that can be drivin on a daily an keep my 305 to show respect to my grandfather.... this is the run down on the 350 that im going to build
1.gettin it bored .40 over
2.vortec head (GM)
3. this is the cam of choice comp told me it would be the right cam for the set up im going for a nice choppy sound but still can drive on the street
Part Number 12-316-4
Intake Exhaust
Valve Adjustment 0 0
Gross Valve Lift 0.464 0.464
Duration At 0.006 Tappet Lift 268 268
Valve Timing At 0.006
Open Close
Intake 26 62
Exhaust 62 26
These Specs Are For The Cam Installed At 108 Intake CL
Intake Exhaust
Duration At 0.05 222 222
Lobe Lift 0.296 0.0296
Lobe Separation 108
intake will be eldebrock 2116
carb will be the edlebrock 1806 thunder 650 cfm
let me know what you think about this set up let me know if it good or not

What is the figure in degrees where the intake closes ABDC @ 0.050"?

they didnt have it at .50

Intake Exhaust
Duration At 0.05 222 222
Lobe Lift 0.296 0.0296
Lobe Separation 108

i guess this is what you need here it is let me get some feed back ASAP

Call Comp back and ask them where the intake closes. I can only help you if I have the tools to make the right decision for you.