Thread: gen III heads on a gen I block
-
04-07-2006 10:02 PM #1
gen III heads on a gen I block
do they fit?
-
Advertising
- Google Adsense
- REGISTERED USERS DO NOT SEE THIS AD
-
04-07-2006 11:03 PM #2
Nope, they have only 4 head bolts, they are set up for a reverse direction coolant flow where coolant enters at the top of the engine and leaves out the bottom, and their valve geometry is different. The only thing in common between a Gen III and a Gen I small block is the distance between the cylinders.
-
04-08-2006 11:50 PM #3
Too bad they don't fit, somebody ought to make a set that fits the gen 1 block.
I didn't think the GenIII motors were reverse cooling like the Gen2's, I'll have to check into that again.
The Australians have finally discovered the origin of the word 'Vegan.' Apparently it's an old Aboriginal word for 'Bad Hunter.'
the Official CHR joke page duel