Originally posted by erik erikson
I was not really trying to up-set anyone.Let me ask you this would you rather have your machinst/engine builder use a $200 mic and a $500 inside bore to check everthing or 25 cents of plast-gauge? It is a very good engine building practice that I use on $1,500 engines or $15,000 engines.It makes me feel better knowing I did my best.
if you don't use plasti gauge when you torque you're rods and mains down the last time, then you're not building the best motor you can. plasti gauge and mics. are only as good as the man reading them.