Crankshalf Barings and Rod barings

Quote:

---

Originally posted by erik erikson
We where told by our oil manufacture we could close the clearence back up because of our synthetic additive we where useing.Yes, it was the heat of the summer and the rings where a little on the loose side which we think let more metanhol wash down the cyinders and into the oil pan.

---

Methanol will definitely wash the cylinders and cook some bearings!!! Used to run the rings in the sprinter engines tight and the bearings to manufacturers spec and ran on Mobil 1. Never had much for bearing problems...

Everytime I get my "package" figured out for the Ranchero engine I keep running across new trick goodies I like, then have to go back and make everything else match. The really scary thing is going to be the cam!!!!

:LOL: :LOL: boy i wish .on the h bearings that is damn close to the same way i run them and had very good luck .001 pre of inch journal on something that get hammered on hard i will allways open them up a bit more i am big on hi crush on my mains and rods

Quote:

---

Originally posted by Henry Rifle
I'm using a sundial from now on.

---

I have a moondial stop watch, used to use if for timing laps in night races with the sprinter.....

Quote:

---

Originally posted by Dave Severson
I have a moondial stop watch, used to use if for timing laps in night races with the sprinter.....

---

Oh,stop some people might think that is true.:LOL:

I've heard some of the chebbie guys are timing their stuff with a calender!!!!!:LOL: :LOL:

Quote:

---

Originally posted by Dave Severson
I've heard some of the chebbie guys are timing their stuff with a calender!!!!!:LOL: :LOL:

---

They are using the calander to record all their wins!! :LOL:

hey slow down you guys so i can keep up:LOL:

Quote:

---

Originally posted by pat mccarthy
hey slow down you guys so i can keep up:LOL:

---

O.K.:LOL:

hey dave be nice on the chevys i did not say any thing about fords

Quote:

---

Originally posted by pat mccarthy
hey dave be nice on the chevys i did not say any thing about fords

---

:whacked: :whacked: Just getting tuned up for the CHR Shootout, Pat!!!!! Ya know we are going to have to have one someday, aren't we????????

hey dave i was a ford man had a 34 ford truck with a 400 M in it and a c6 i built in my room when i was 14 years old wish i had that truck was chopped :CRY:

Quote:

---

Originally posted by Dave Severson
:whacked: :whacked: Just getting tuned up for the CHR Shootout, Pat!!!!! Ya know we are going to have to have one someday, aren't we????????

---

you bet i will be in the wheel chair with the 656 donovan in it :LOL:

Kewl, I nominate Pat to head the CHR Shootout planning comittee. My vote would go for early summer, 2008 someplace in the middle of the country. Some place with a good drag strip. Never know, plan something a couple years in advance maybe a lot of people could work it into their vacation schedule????????

:HMMM: need to work harder need a trailer to haul the car if any thing sit down with you and erick and have a beer or soda pop that would be cool

Well, definitely something to think about for someday. Sure would be a blast!!!!