Hey, Im building a 383 stroker motor the bottom end is keith black silvolite pistons 60 over and .100 domes, h beam rods with a cast crank. The top end i just bought a set of 049 bowtie aluminum heads with ferrea 2.08 1.60 valves and roller springs im looking for a good cam that i could run down the strip with, i was looking at getting a bowtie intake with the .200 raised runners, and i have a 780 dp holley with a 150 shot. The trans is a built th350 with a 3500 stall and i want to put a 4.56 gear in i already have the posi unit. This is all going to be in a 78' nova im just looking for some pointers on the cam.. solid? hyd? roller... and what should i run for a stall.. i have the 3500 but should i run a bigger on.. it would b nice to drive on the street.. well any input would be appreciated.. thanks Justin