Threaded View
-
06-11-2017 07:20 PM #5
You can always mill out your spread bore intake to accept a square bore carb, as the Edelbrock carb will accept the spreadbore bolt pattern, very simple operation for a machinist I have seen it done a bunch to cure the problem you have encountered, and done a ton on early hemi original intakes (they where originally spread bores), I had it done once years ago for $25, it was cheaper than the adapter, you just have to pull the intake.Why is mine so big and yours so small, Chrysler FirePower
On a bitterly cold winter morning a husband and wife were listening to the radio during breakfast. They heard the announcer say, "We are going to have 8 to 10 inches of snow today. You must park...
the Official CHR joke page duel