Need some advice about chaining a engine any input on fabrication or am I better of getting a torque strap or solid engine mounts..bbc
Printable View
Need some advice about chaining a engine any input on fabrication or am I better of getting a torque strap or solid engine mounts..bbc
it`s been a few hundred years since i seen a factory chain or cable on an engine when i worked at the junkyard .. i dont even remember which car had it .. someone should ..
In what vehicle for what purpose?
i run my big engine solid mount upper teeth still in my head . urethane is the best for many . can make up a torque link and used urethane bushing or sway bar bushing kit but bigger then a 5/16 hole min of 3/8
I've got a 'link' from my frame to the front of the motor, kinda like an alternator adjuster, you know , with the long slot.
Only my link has slot only about 3/4" long so that is all the motor can move before getting pulled up short.
Depends on the use of the motor and the car. If this is a competition motor, where driver comfort is secondary, then solid motor mounts or motor plates front and or rear will prevent the motor from torquing over toward the passenger side of the car. If this is a street motor and you are concerned about the motor torquing over and driver comfort is a consideration, use stock rubber mounts and install a torque strap from the front-most cylinder head bolt to the upper control arm mount on the frame. Such a strap can be made up from small diameter steel cable and parts at your local home depot or other building supply store. They have bulk cable on spools and you just buy the length you need, along with the ends/couplers you need.
Here's a bad example of a chain used for the purpose....
Engine1-Copy.jpg Photo by marlinguy | Photobucket
Here's a more sophisticated arrangement with a solid strut....
http://www.engine-swaps.com/Photos4W...alled%20bw.jpg
Here's a chain run from one of the accessory bolt holes in the front of the head down to a frame bracket....
TorqueStrap001.jpg Photo by dennis_8047 | Photobucket
Here's a very ugly homemade installation of a cable....
http://www.alfabb.com/bb/forums/atta...rque-cable.jpg
Here's another solid rod installation....
2011-04-29011.jpg Photo by kricka | Photobucket
.
thanks for the help this information was useful. im putting a 496 stroker in a 85 k10 pickup with six speed tranny dana 60 front and gm 14 bolt rear 4.10 gear its a muscle truck i guess
the reason for the chain i made a custom set of headers because no one makes them with two inch primaries for that truck unless you want to spend 1500 so anyways because of clearance issues with the transfer case and front drive shaft an diameter of the pipe i had to hold them kinda tight to the frame im afraid when i put my foot in it there could be a problem plus the less the engine rock more power going back where you want it i could just go two wheel peel seeing how its gonna be a pavement pounder i live in Vermont i my be tempted to go offroad want 4 wheel i have six inchs of lift and thirty fives under it