I have a 560 cu in BBC that filled the #3 cylinder with water. Showed up for a test n tune and car would not turn over. Pulled all the plugs and water poured out of the #3 cylinder. Motor only has idle time and about 10 passes on it and seemed to be running good. Got home and pulled the head and it looks like the head gasket had been leaking since start up as there is rust and some scaring in the cylinder from water sitting in it. I hope a hone will clean up that. The block and heads were decked before assembly and there is no visual defects. I currently am using the multi-layer felpro's which I was told were a good choice. Is there something else better I could use? Motor is over 14:1 if that makes any difference and runs on gas.
thanks
Scott