Part # from the speed-pro box reads, H727CP digging through summit i found this, Dish with 2 valve reliefs, and compression distance shows 1.625

I work out of town all the time so i will not be able to check the deck untill this weekend, im pretty sure there were no gasket marks

I will take your advice and step up to a roller cam, have been wanting to and i suppose the budget cut from the $1300 alumanum heads to a set i already have can warrant the extra expense involved on the switch.

Will be getting this block on the engine stand this weekend so with any luck i can get some specs posted...i would rather go through the hassle now and know my engine then try to figure out later where i screwed up when the engine doesnt meet my needs, thats why i ask questions first, rather than throw a huge cam in it and expect it to run good