Thread: What would you do with this!!!!!

Tweet

i have all goods there steel crank,454 2 bolt ,edelbrock RPM 6055 marine heads ,offenhouser 360, and i need advice what to built it and what to put in ,to make nice HP thanks

what are you building ? drag street strip what rpm how much money do you have to spend on the build . there many ways to go been there done them all

1972 nova ,i want to run pump gas ,hi perf street rod

well if you got crank, block and heads-----pump gas--round 10-1 compression--decent cam, oil pan and exhaust that will fit your chassis--stick shift and headers create clutch problems in the Nova, but auto helps--probably remote oil filter--

get rid of that manifold

Killer rat rod motor. For anything other than full race, get rid of the intake. Single carb on correct intake will make plenty of power. Tunnel rams are good for high RPM motors and lightweight rods. I love the look of a tunnel ram, but they don't perform til well up int he RPMs.

Thanks guys for or the info,I love the look of tunnel ram to ,I have another intake performer edie,what pistons should I uss ,and rods,I have muncie M20 for my nova try to get bellhousing 621 and run 11"clutch,will this set up support this big block?

i have use tunnel rams on the street they can work on the street the bbc will take them better then a smaller engine.if you like to play with that stuff they can work BUT i would say to lose the tunnle ram as well

Yep I will rid of the tunnel ram then,and uss edie with 750 thunder carb,forged or cast pistons need to uss ?I just got this heads and single carb intake for good price,now I try to find some pistons to put in

well that up to you on the piston speed pro make hyper pistons. or srp forged there others as well .the speed pros are now made in inda. they were so so .just look them over good

Thanks for the info,I think I will bore 60 over,and uss KB hyp.