Hi guys,

Stupid questions but I haven't done it before...

I'm going to pull my intake to check lifters and want to know how much and where to put sealant (planning to use black RTV, is this right?) when I put it back on. Same sealant for the bolts? How much to torque the bolts? What is the correct torque pattern?

Aluminum Holley Strip Dominator intake and aluminum TrickFlow Oval heads... Going to use Fel-Pro 1212 gaskets.

Anything else I need to look out for? As for checking the lifters, I figure rotate the crank to pull each rocker when fully closed

Thanks,

-Chris