plasty gauge... an double checked with mics....
the rods are around 2.1975 too 2.1955. with standard bearing coated(king)

and about the same with the mains. .0043 too .0048 at the thrust. i planned on running around .002 too .0025 standard volume standard pressure pump setup.

i thought i told him to have it turned and polised in, but they just polished it..

this is not good. or should i just suck it up and put a high volume/ high pressure pump in? IMO its too much. can i pick you brain on the phone pm me a number if you could...