I have a 396 bored to a 408 at the moment. and I am putting up what is all going into the motor. Tell me what you guys think, estimates as to HP, etc..
Thanks.
408 BBC
Forged crank, balanced up to 10,000 RPM's with 2 pounds of weight throwing off . before balance it was 600 pounds!
truck rods, stock length
292 heads, 113 open chamber. Heads have 3 angle valve job, 2.06, 1.72 valves, new guides throughout, blue racer springs (single spring), slightly ported, bowl blended.
KB hyperutectic pistons, 17cc dome
Xtreme Energy XE262H Hydraulic Flat Tappet Cam
Lift: .504/.510"
Duration: 262/270
Duration @ .050 Lift: 218/224
Lobe separation angle: 110
RPM range - 1300-5600
edelbrock performer intake
edelbrock 4 barrel carb, 650 cfm
msd distributor

Headers, with flowmaster 40s
Should run 9:1 c/r
What do you guys think this combo would make approximately.
any suggestions?