Threaded View
-
02-02-2007 08:58 PM #8
Originally Posted by pat mccarthy
im gonna deck them .005 just to be a straight head, new guides, 3 angle job, clean job.
Welcome to Club Hot Rod! The premier site for
everything to do with Hot Rod, Customs, Low Riders, Rat Rods, and more.
YES! I want to register an account for free right now! p.s.: For registered members this ad will NOT show
Alright, also, I'm pretty sure on the 820 head, somebody wrote with a permanent marker 2.19/ 1.88. so Id assume they're cut that big. but i could be wrong, im trying to find more info on valve sizes for the 820 but no luck yet. I measured the middle groove of the 3 angle that is present on both heads, approximately accross. and both came up at 2 and 3/16ths. im not sure what that translates into decimals but. They appear the same, but i best bet bring em in when i get work done to them at the machine shop and have them fit a few valves to check.Originally Posted by pat mccarthy
im gonna deck them .005 just to be a straight head, new guides, 3 angle job, clean job.
John's ride to the cemetery, his beloved Billings OK bus, The Baby Elephant!! Traveling in style!! As his service was starting I couldn't figure out what the music was, heavy on a flute in a jaunty...
John Norton aka johnboy