Thread: solid lifter valve lash setting
-
12-16-2006 04:21 PM #1
solid lifter valve lash setting
i have been asking around about setting the valve lash for a solid lifter cam
the cam card says set the intake at .022 and the exhaust at .024 hot
what would you set them at cold ?
thanks
Richard
-
Advertising
- Google Adsense
- REGISTERED USERS DO NOT SEE THIS AD
-
12-16-2006 04:40 PM #2
Set them a few thousandths wider, warm the engine up good and reset them hotYesterday is history, tomorrow is a mystery, Live for Today!
Carroll Shelby
Learning must be difficult for those who already know it all!!!!
-
12-16-2006 04:44 PM #3
ok , that is what i am doing , i added .004 to them for the start up , you think that is enough ?
-
12-16-2006 04:55 PM #4
should be plenty... I usually go 4-5 loose on the warm up on a new set....Haven't broke anything yet!!!Yesterday is history, tomorrow is a mystery, Live for Today!
Carroll Shelby
Learning must be difficult for those who already know it all!!!!
here's the latest, I had to cut up the cross section of the frame to get the parallel bars in place and these pic's show my fix . 3 x 6 tube used to rebuild the frame section. [/URL] after lots...
New Project