i have been asking around about setting the valve lash for a solid lifter cam
the cam card says set the intake at .022 and the exhaust at .024 hot
what would you set them at cold ?
thanks
Richard
Printable View
i have been asking around about setting the valve lash for a solid lifter cam
the cam card says set the intake at .022 and the exhaust at .024 hot
what would you set them at cold ?
thanks
Richard
Set them a few thousandths wider, warm the engine up good and reset them hot
ok , that is what i am doing , i added .004 to them for the start up , you think that is enough ?
should be plenty... I usually go 4-5 loose on the warm up on a new set....Haven't broke anything yet!!!