Thread: intake spacer kit and distributor angle

Tweet

Originally posted by mikekgvk
Tech inspector understands what i'm asking. I attached a diagram detailing the question i'm asking. Note: the relocation of the hole where the distributor would enter the intake. By using intake spacers, wouldn't the correct angle of the distributor have to change?

yes i do understand . like i said this will not change the the center line .you are going to and add two spacers one to each side of the intake . yes the dist is at a very slight angle but not very much . what you are thinking has never been a problem .i have had to spot face the dist hole before so yes it is at a angle but very sligth you would have to move the intake up alot more then 400or370 to make this a problem