Originally posted by mikekgvk
I understand that a slip collar distributor would be required. But my question is, by using a standard deck heigth intake combined with an intake spacer kit for use on a tall deck motor, what effects would there be due to the angle of the distributor changing?
what angle?? i have done many tall decks if the in take is 400 to 375 up then the distributor needs to go down 400to375 yes you can run the gear to far down or up and wear on the gear or wear the oil pump out this runs the oil pump gears in the oil pump plate you need to check the pattern on the gear but you must have it far enough to drive the oil pump and make a good setup pattern on the gear the angle is not change on the dist