-
you could run the 6.700 rod pin 1.250 so the 1.200 would work if you deck it. on the rod 6.800 pin 1.150 why ? tell me why you think this ?? less piston the harder it is to keep the ring s on the walls and the more weigh there is in the mass more money to balances it you can spend a $1000 just to get something balances if it needs mallory metal in the crank. have been there . joe look i guess i can not help you ? all i have tried to keep you going down the road were you will not spend more money and not see much from it. but you do what . there are more than one way to go. but i have been there so if i tell you a 400 rod. this is it. this is the best way to go. the affordable way . this is the way i think .on this you will not see the longer rod help you . i think them pistons you are looking at are a bit more than 600 a set ?? any thing i put down in this post i have done. not seen or read or on tv somewhere. a lot of my bigblock do not get dyno. BUT they get ran very hard .so if i think you need a longer rod i would told you get them.
-
Ok I trust you fully. I was just checking all the opstions I had I am not dowting your work trust me I know you and a lot of others have way more experince than I do. I will do it the way you have told and I was probobly going to from the begining I was just seeing what els I could do. Sorry if you thought I thought diferant. And I do apretiate the advice I class it as very good advice.
-
no big deal joe. just want to make shure you do not wast any money on something i do think that will help that much
-
Well thank you and hopefully I will have the time and money to come to your shop. I am short on cash again because my tranny went out in my truck. 700R4 are junk, waste of time, that is my third one. Not in that truck though. Thanks again.
-
