Thread: Ford c6-aod conversion
-
07-15-2010 02:58 PM #1
Ford c6-aod conversion
Well I ditched the c6 and have the aod in my monterey. Only issue is that the universal joints that work on the drive shaft are too long for the aod slip yolk. Is there an easy way to work around this? I thought about grinding a little bit off each end of the universal joint but wasn't sure if that was a safe idea."Caffeine is the glue that holds my macaroni picture together, nicotine is the magnet that holds it all up on the fridge."
-
Advertising
- Google Adsense
- REGISTERED USERS DO NOT SEE THIS AD
-
07-15-2010 03:53 PM #2
Do not grind. speedway motors has conversion u-joints that will work
-
07-15-2010 11:39 PM #3
Look up drive shafts in your local yellow pages take the drive shaft and yoke with you,most stock conversion joints by NEAPCO.
This popped up on Facebook, one of those "Do you mean for the last 40 years..." moments. A drop dead easy and accurate way to check Toe In! -
Toe Adjustment