Thread: sticky hughes converter
Threaded View
-
07-11-2009 01:17 PM #1
sticky hughes converter
I am just putting a 8 inch hughes converter in my powerglide. I have had a B&M converter in it and it slid in and out and once the tranny was bolted up it still had about 1/4 in. to spin free until I bolted it to the flexplate. i as going to replace it with the Hughes 8 in and put it in the tranny, made sure it went in the second notch and bolted it up. The converter will turn, but there is almost zero clearance between the converter and flexplate. Is this normal or should I pull it apart and reinstall
Thanks, Terry
My wife told me the kitten needs to be chipped. I had only a 9 iron but I still got it over the shed.
the Official CHR joke page duel