C6 Valvebody, transgo reprogramming...

Hello!
I used a transgo kit to overhaul and update my C6 valvebody...(transgo-kit 67 1&2)
everything went okay, untill I got to the scheduling valve...
I added two pictures to visualize my problem, but here it goes;

the original spring is like a 3/4 inch long, the new spring is only about 1/4 inch, that said, the new spring is also like having coilbind...there's no travel at all

the instructions show a slightly different spring also, so my question is: what's wrong in this picture? I can't fit the valve without any springcontrol, that won't be the answer, now would it?
since it is the sheduling-valve I think this wil be quite an important part of the update and i probably cannot re-use the original spring, with all the other springs swapped already...??
what am I missing here....or is this the wrong kind of spring? or should i add this spring to the original and then mount both the two springs and valve?

any advice is appreciated here!
grtz,
Tom