Originally posted by R Pope
I'd shim your back mount up 1/2" or so.
The transmission is dropped by installing two steel blocks on each side of the transmission mount. I'll shave off 1/4" to 1/2" from those blocks which will put the yoke 1/2" or more above the frame. That should do it I hope.

Any more comments on how far out the yoke is? I had the drive shaft custom made and the shop decided that this was the proper length. I thought it looked a bit too short, and now I'm not sure if I should take it back to the shop or not. When I put a load on the suspension, the yoke is still about 1 3/8" from the housing. Is that too much?