Hybrid View
-
02-10-2005 09:29 AM #1
clutch fork linkage????????
I've looked through a million threads to find a picture I stumbled across one time. Somehow a topic turned into a discussion about clutch linkages and somebody posted a picture of their linkage from the pedal to the fork. The fork in this case was basically perfectly straight ahead of the pedal.
I wanted to get a look at it because my fork is almost straight ahead and I'm trying to figure out what linkage pieces I'll need to get it to work right.
I kind of think it was dennyw who posted that pic, but I'm not sure.Last edited by tcodi; 02-15-2005 at 01:19 PM.
-
02-11-2005 04:22 AM #2
that's the one
I couldn't find it
thanks
-
02-15-2005 11:01 AM #3
Here's my problem. I have through the floor pedals, so the tab underneath the clutch pedal pivot goes towards the rear when depressed. It is in a fairly straight line to the clutch fork, which has the dimple on the front of the pedal. I guess most mechanical linkages use the z bar thing, but is there anything I could use that would wrap around the front of that fork so that I could use a straight linkage to the pedal tab?
I would use a heim joint of some sort, I'm just not sure how to connect to that fork.
It looks like henry rifle must have done something similar, but I can't see enough in this picture.
The Australians have finally discovered the origin of the word 'Vegan.' Apparently it's an old Aboriginal word for 'Bad Hunter.'
the Official CHR joke page duel