Thread: frame measurement?
Threaded View
-
11-25-2008 08:15 PM #1
frame measurement?
I am building a bobber car and it is about time to start designing the frame. I have slid the rear axle up behind the car in the place I wish to put it and the same with the front. Now all that I need to know is where to start. Do i start at the front and measure off the top of the leaf spring, or do I start at the back and measure off of the coil overs? I am planning on kicking up the back end to get a little extra drop and will try to get some pictures of the car I am building, so you can get a little bit better picture of what I am trying to do.
Well I've sure gotten old too so don't worry about it! I've had two bypass surgeries, new knees, fought prostate, cancer and diabetes. I'm half blind, can't hear anything quieter than a jet engine,...
the Official CHR joke page duel