Thread: Dyno-Sim combinations

Tweet

Let's do a down and dirty 360 build with a lopey cam. (350 block bored 0.060" with 882 heads, Comp Thumpr cam, stock cast iron intake manifold with 600 carb, stock cast iron exhaust manifolds and mufflers.
This head gasket...
Fel-Pro Head Gaskets Q7733PT2 - SummitRacing.com
These pistons...
Summit Racing® Hypereutectic Pistons SUM-17350-60 - SummitRacing.com
Cut the block decks to 9.000". The stack will be 9.000" for a zero deck.
We'll use stock cast iron SBC production heads, casting 882, 76cc chambers, 1.94"/1.50" valves, Comp 981-16 springs.
Use this cam, install advanced 4 degrees....
12-600-4 - Thumpr
Actually, the K12-600-4 kit with cam, lifters, springs, retainers, keepers, seals and timing set might be a better deal than buying individual parts.
Static compression ratio will be 9.16:1, dynamic compression ratio will be 8.22:1. Squish will be 0.039". Idle will be choppy/thumping.

RPM HP TQ
1000 37 194
1500 85 296
2000 125 328
2500 162 340
3000 201 352
3500 240 360
4000 261 342
4500 275 320
5000 275 287
5500 259 247

Max volumetric efficiency 84.6% @4000
Max BMEP pressure 150.5 @3500
Not bad for a low-buck, mostly junkyard parts motor in my opinion.