Thread: Framed

Tweet

BEEN CRUSING THE WEB FOR ABOUT 6 MOS. LOOKING FOR PRINTS/DEMINSIONS FOR A '27 T FRAME.SEAMS NOBODY WANTS TO GIVE UP THE GOOD STUFF!

OH,MAYBE I SHOULD HAVE SAID,THE LOCATIONS OF MOTOR AND TRANS MOUNTS FOR A 350/350 COMBO IN A '27 TRACK T. THE BASIC FRAME IS ALREADY IN MY GRUBBY LITTLE HOT RODDING HANDS.

have you installed your radiatior? and is your body bolted to frame?
If so just center the motor between frame rails , determine the height for tranny and drive shaft angle and make sure you have room for a fan behind radiator, and you might have to cut the firewall and move it back a tad to get the motor fitting , then just build motor mounts and weld them to the frame.
Its how i did my 37.

SprayTech