Thread: Bolt extraction...
Threaded View
-
05-19-2004 06:15 AM #1
Bolt extraction...
I recently bought a used intake manifold from a Mopar swap meet. After getting it thermal cleaned and painted I realized as I was putting the carburator on that there was half of a bolt stuck down in one of the four holes. I bought a bolt extraction kit but I have been told two different ways of doing this.
So... Do I simply drill the bolt extractor in reverse all the way down inot the screw until the bolt starts unscrewing?
Or do I drill a tiny hole in the screw and then drill the extractor into the hole?
And if neither of these is correct then may I please get a step by step answer?John 3:16 ><>
John's ride to the cemetery, his beloved Billings OK bus, The Baby Elephant!! Traveling in style!! As his service was starting I couldn't figure out what the music was, heavy on a flute in a jaunty...
John Norton aka johnboy