Making a new label for the '56's heater control
I am wrapping up installing a new HVAC unit in the '56 wagon. The new box is all in, the A/C and heater lines are in, the wiring is mostly done and I have a new outlet and some ducting to install.
One snag I had was getting a new label for the blower control switch. Finding a piece of material with the same kind of texture as the V/A labels was the hard part, until I looked at one of the 3 1/2" floppy discs my shop camera uses...
This is the old layout.
https://media.fotki.com/2v2EHJCSkx9EDKg.jpg
This is what V/A sent for a label. It would work well on their plastic panel, but not on the original Chevy one... The floppy disc it is pictured with is a perfect match for the texture...
https://media.fotki.com/2v2EHJCC4x9EDKg.jpg
I tore apart a junk disc, sanded down the back side to remove some molded on ribs and trimmed out a new panel.
https://media.fotki.com/2v2EHJC5mx9EDKg.jpg
https://media.fotki.com/2v2EHJCrSx9EDKg.jpg
This covers up all of the old lettering and gives room for new graphics.
https://media.fotki.com/2v2EHJL24x9EDKg.jpg
Some dry transfer lettering and we are in business!
https://media.fotki.com/2v2EHsW5jx9EDKg.jpg
I layed the new panel over the old one to get the graduations in the right place.
https://media.fotki.com/2v2EHsGvnx9EDKg.jpg
https://media.fotki.com/2v2EHsGJCx9EDKg.jpg
https://media.fotki.com/2v2EHsGaWx9EDKg.jpg
I'll spray some matte clear on this to protect the lettering. This will work great!
Thanks for looking!
Mark