1Likes
Thread: tunnel clearance
Results 1 to 3 of 3
LinkBack URL
About LinkBacksHybrid View
-
02-09-2016 11:10 AM #1
CHR Member
- Join Date
- Mar 2014
- Location
- prescott
- Car Year, Make, Model: 28 tudor
- Posts
- 20
tunnel clearance
Hi all,
looking for some advice, I am fabbing a floor and trans tunnel for a 1929 model a project, I need some advice as far as clearance between the sides of the drive shaft and the tunnel, the body is channeled 4 inches so the tunnel is pretty tall, the rearend is a ford 8.8 with coilovers and will have a panhard bar and has a four link set up, not sure how much side to side movement to expect any advice is greatly appreciated, thanks
-
02-09-2016 08:22 PM #2
CHR Member
- Join Date
- May 2005
- Location
- Tataraimaka NZ
- Car Year, Make, Model: `47 Ford sedan, A.C.Cobra replica.
- Posts
- 2,895
Post #33 from this thread by Jerry Clayton.
the shop tips threadjohnboy
Mountain man. (Retired.)
Some mistakes are too much fun to be made only once.
I don't know everything about anything, and I don't know anything about lots of things.
'47 Ford sedan. 350 -- 350, Jaguar irs + ifs.
'49 Morris Minor. Datsun 1500cc, 5sp manual, Marina front axle, Nissan rear axle.
'51 Ford school bus. Chev 400 ci Vortec 5 sp manual + Gearvendors 2sp, 2000 Chev lwb dually chassis and axles.
'64 A.C. Cobra replica. Ford 429, C6 auto, Torana ifs, Jaguar irs.
-
02-10-2016 07:03 AM #3
CHR Member
- Join Date
- Apr 2004
- Location
- Little Elm
- Car Year, Make, Model: 34 Ford Low Boy w/ZZ430 Clone
- Posts
- 3,890
How long is your panhard bar, what angle are your coil-over, and what is their total travel? I can calculate sided to side with those numbers.Jack
Gone to Texas
Reply With Quote
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
Either return this forum to what was or get the HELL OUT!
Dead!