sealed power E251K30 piston rings

[Jeri]

Quick question. I accidentally spilled my piston rings on the work bench and before I put the rings on the piston I wanted to check with you guys to make sure I am doing it right.

I need to know which is the top ring and which is the second ring?

One of the two top rings is a little wider than the other. Does the wider ring go as the first (top) ring?

Appreciate your help.
Jeri

[glennsexton]

Welcome to CHR, Jeri!

The top two rings in your set are both 5/64” thick and both have a dot on the top of the ring but that is where the likeness ends! The top ring does about 80% of the compression so the installation is critical. The top ring is a lot stiffer that the second ring. The second ring will have a bevel on the on the opposite side of the dot and will be noticeable easier to compress.

See below - From our friends at Hot Rod Magazine.

When installing, put the oil rings on first, then the second ring and finally the top ring.

Remember to offset the end gaps between the top two rings.

[Jeri]

Thanks for the info.. Very helpful.
Jeri

[glennsexton]

.030 over 350 - going in the '40 Ford, Jeri?

[Jeri]

New project. This 350 is going the in 30 ford coupe.
Again, thanks all for your input.
Jeri

[rspears]

New project. This 350 is going the in 30 ford coupe.
Again, thanks all for your input.
Jeri

useless_without_pics_2.gif.jpg

Jus' pullin' your chain, but then again, we DO LOVE PICTURES!!!

[Jeri]

Give me a couple of weeks and I hope I will have some picts worth showing.
Jeri