-
As some of you may remember last month I received an email from a guy who was willing to supply me with drop hammered corners. We did some haggling and bartering and came to a place where I can acquire the end caps I needed without starting from scratch. While there is still a good bit of work in the end caps once i get them I do save time when compared to starting out with a flat piece of sheet metal. The time saved makes it possible to build these while keeping the price at an affordable level for most I believe. I have built 2 roll pans with the new end plates and have already sold them and shipped them off. So with that said if anyone would like a nice and unique roll pan for a 28~31 Coupe or Roadster Model A Ford let me know and I'm sure we can work something out. Thanks
Bob,Bob, & Bob
-
3 Bobs, my advice would be to put an ad in the HAMB parts classifieds and I bet you sell quite a few of them. I doubt it will take long to get them out and about before you're too busy than you know what to do. :LOL:
-
Thats a wonderful idea, think I will get on that right away! :cool: Ok, truth is they have been my guinea pigs on these for a few weeks now. Figured I would perfect them over there and then when I knew I could keep up with the demand with the new corners Id would open the doors a bit! They seem to like them so who knows? I doubt I will be building that many of them though. I did just add them to my new products page on my site so we will see if they gain any traction. Now I need to remember to take some good pics, then the ball will be officially rolling. Thanks for the heads up! http://i52.photobucket.com/albums/g2...M/thumbup1.gif I will pass this on to Bob2 and Bob3
-
-
They look very nice! I knew they'd sell easily!
-
Glad you did... I wasn't so sure. LOL