016 Front left bumper mount.jpg
Thanks for all your feedback.
The doors are said to have wood frames in them that I'm planning on replacing. That will be easier for me because I have done a lot of woodwork through the years and have a lot of wood working equipment.
I'm planning a frame off build and I have a local oval track shop lined up to do the suspension and chassis work.
I'm just trying to get a handle on the whole project before I start spending cash. The more I save now leaves more for a better paint job.
The rust at the front of the front fenders and below the grill is also bad. See picture.
Questions I'm trying to answer:
1) Do I need a welder (or can I use just panel bond process) and
2) if so, should it be 115 volt or 230volt.
Some tell me to buy 230volt and some say 115V will suffice. 230V are $400 more and require me to add another circuit to my garage for another $100 in materials.
This is probably the only car I will use the welder on and all the chassis welding will be done by the track car shop.
I'm going for a 95% rebuild that will be a daily driver.
Thanks for all your help