Thread: Drive shaft question
Hybrid View
-
09-24-2011 11:03 AM #1
Drive shaft question
What is the normal runout on a drive shaft I've got some bad vibration front is out of round .015-.025 middle is .035 back is .052
-
09-24-2011 12:55 PM #2
I've read that driveshaft runout of 0.004" to 0.005" is OK for street use, but you're ten times that. I'd say you may have found your source.Roger
Enjoy the little things in life, and you may look back one day and realize that they were really the BIG things.
-
09-24-2011 04:01 PM #3
A lot of drive line vibration comes from untimed, unaligned U joints---- does yours vibrate on acceration or does it get worse with speed???
Moving on to next phase of frame reconstruction . Due to the Trans location I need to build a new center section for the X member. 1st cuts have been made . [/URL] I will use this 6"dia. ...
New Project