I have an '49 chevy with a viper V-10 in it. I am having the exhaust exit through the side of the running boards, about 6 ft behind the engine. How do i keep the tips from burning the paint? theres about a half inch of separation between the top of the tip and the bottom of the running board, so i figure heat tape or that aluminized heat shielding material (common on new cars) could go between there and shield it. But where the tip exits the running board theres not much room to create separation, what else could i do? I could get about 1/8 inch separation around it max, but it would then look sloppy. Suggestions?IMG_0898.JPG