Temp sensor location: 4.6 L Lincoln

[ohekk]

OK...I built this 51 Merc ( NOT "Old Sckool").

It has a 95 Lincoln Mark VIII 4.6L 32 valve DOHC.

I've said this before and I'll say it again: I'm electrically challenged!


Coolant temp sensors: I've found 3 so far but I'm sure they are wired in the ECM.

I'm using Stewart Warner guages and I'm stumped where the temp sending unit should go.


Here's a few pics51 MercS.JPG51MercS1.JPG51MercS4.JPG51MercS5.JPG51MercS3.JPG

[sunsetdart]

There are two ways you could go with this.
1.If this motor has the crossover tube from one side of the manifold to the other, you could weld a bung in the middle of the tube for the gauge.
2. You could put the gauge in the upper hose. Cut the hose and use a metal connector and put the sending unit for the gauge in it.