It was something like that Bob, pretty sure. I'll be at the shop tonight and will shoot some pictures and take some measurements. I think it took me all of an hour to fab up mine, it was that simple.
Don
Printable View
It was something like that Bob, pretty sure. I'll be at the shop tonight and will shoot some pictures and take some measurements. I think it took me all of an hour to fab up mine, it was that simple.
Don
I took three pictures for you but for some reason my computer is screwing up and I can only download one. But it shows pretty much all there is to see. The chrome nut is simply capping an all thread rod that I cut so that only a bit hung out on each side. As I tightened the two nuts it drew the horns in, locking in the spreader bar.
I measured the diameter of the bar, it is 1.5 inches OD, and that seems pretty proportional to the rest of the frame. Hope this info helps out.
Don
And it looks good Don!!!
Kurt
Looks great :)
I'll most likely do the same :cool: