Printable View
I have a Ford 9" Traction Loc 3rd member for 31 spline axles. Can this be changed to use 28 spline axles? I'd like to use it (in my '48 F1) in a '71 F100 rearend that has the 28 spline axles. The '71 has the right hub-to-hub length, and the spring perches are located for direct bolt-in to the '48.
Why? Why don't you buy new 31 splin axles for the other rearend?
The 31's are stronger than the 28's, why would you want to weaken the rearend by doing that? If your gonna do that, I would just leave the other rear end in there if it still works. Just my two cents. Kurt
Kurt....I'd like to use the 31 splines, but I was told the 31 spline axle has a larger bearing, and won't fit the '71 rear end. I guess I need to check into that a bit further. My 3rd member is coming out of a 1989 F-150, and that unit is about 5-6 inches too wide for my '48 F1, and the spring perches would have to be relocated as well. The '71 rear end that fits right in is a non-posi. I stiil haven't decided whether or not to do a leaf spring set-up, or a 4-link.
yes you just need the correct 28 spline spider gear set
What is the rear end housing's are the both the same?
I know a guy that takes 28 spline and mill's it to a 31 spline.
So I think you could buy axles for it, if the housing's are the same.
Someone correct me if I am wrong Please. Kurt
Kurt...I won't have the '71 housing until Monday, but I was told that housing has smaller smaller bearings and there is likely not enough meat to open the housing for the larger bearings used with the 31 spline axles, without weaking it significantly.
My bad roofcam I thought if the housing's were the same you could use your third member and some shorter axles or cut down axles. Kurt
contact Randy'sRing&pinion for side gears
No need to say more!Quote:
Originally Posted by jerry clayton
Pat
thanks Pat